This original article was first published in The Dot Connector Magazine, Issue #11.

On August 3, 2010, a C3-class solar flare caused a coronal mass ejection that headed towards the Earth. The impact of the flare resulted in a G2-class geomagnetic storm that lasted almost 12 hours. The official story is that the storm caused beautiful northern lights to appear from Europe to North America. Well, that doesn’t seem so bad, does it?

Nevertheless, there has been a lot of talk lately about solar flares and how a big enough solar flare directed towards Earth could knock out electrical grids.  As we all know, sometimes the mainstream media talks up certain scenarios to scare everyone. Sometimes they just make things up entirely. In this case, I sat up and took notice because the power in southern Europe was flickering that night. Lights would dim in a pulsating fashion. That is a fairly rare occurrence. It is doubly strange because according to conventional wisdom, geomagnetic storms cause aurorae and electrical problems mostly in latitudes closer to the poles.

Obviously, some investigation was in order. First, we need to understand a little something about sunspots, solar flares, and coronal mass ejections.

The sun is really big, and really hot. It also generates powerful magnetic fields. Since the sun’s polar regions rotate more quickly than its equator, its overall magnetic field becomes warped. Sometimes, these powerful magnetic fields become concentrated in a single spot on the visible surface of the sun, known as the photosphere. The magnetic fields focused in one spot tend to “seize” the area, causing the spot to become cooler (and therefore darker) than the rest of the surface. Sunspots usually appear in pairs: one spot is like the North pole of a bar magnet, and the other spot is the South pole. The sun’s crazy magnetic field thus creates a “magnetic arc” of sorts that goes from the North sunspot to the South sunspot (or vice versa in the southern hemisphere). Material from the sun sometimes takes a vacation into space along these magnetic highways, from one sunspot to the other. This becomes what we call a solar flare.

Figure 1: Solar Flare

Solar flares are classified as A, B, C, M or X. Each classification has a peak magnetic flux ten times greater than the one before it. Also, within each class there are subclasses from 1 to 9 that indicate increasing intensity on a linear scale. To clarify, let’s assume class A1 = 1:

A1 = 1 B1 = 10 C1 = 100 M1 = 1,000 X1 = 10,000
A2 = 2 B2 = 20 C2 = 200 M2 = 2,000 X2 = 20,000
A3 = 3 B3 = 30 C3 = 300 M3 = 3,000 X3 = 30,000
A9 = 9 B9 = 90 C9 = 900 M9 = 9,000 X9 = 90,000

Table 1: Relative strength of Solar Flare classifications

An M9 flare is 90 times more powerful than a C1 flare, and a C3 flare is 10 times more potent than a B3 flare. Now you know what those crazy classifications actually mean!

The same crazy warped magnetic fields which are thought to be due to the differential rotation of the sun sometimes cause those pretty magnetic arcs that join sunspots to become twisted – exactly like a loop on a rollercoaster. When this occurs, the crossed flux line causes material sucked up from one sunspot to be shot off into space instead of following the path back down to the second sunspot. This is known as a coronal mass ejection, or CME. It looks something like this:

Figure 2: Coronal Mass Ejection (CME)

Now, solar flares and CMEs can shoot off in any direction. Sometimes, they are aimed towards the Earth. When this happens, charged particles and all kinds of goodies go racing across the void and eventually smash into the Earth’s magnetic field.  The so-called “solar wind” is basically the same thing only on a more continuous, lower level; if the solar wind is a gentle breeze, then solar flares might be thought of as stormy wind gusts and CME’s as hurricanes.

Our planet’s natural magnetic field both captures and deflects these streams of charged particles, resulting in what is known as the magnetosphere. During solar flare and CME events directed towards us, lots of energy can get dumped into the Earth’s magnetosphere. This additional energy is like a power surge that distorts Earth’s “shields”, and it can cause all sorts of mayhem. Satellites can be damaged or pushed out of their orbits, radio communications can be disrupted, astronauts can be harmed, and, of course, we end up with attractive aurorae.

All this crazy energy and these wild particles flying around can have serious effects on the earth and human infrastructure. They can produce geomagnetically-induced currents (GICs) in electrical conductors. The simple explanation is that the mayhem occurring in the globe’s magnetic field also results in abnormal electric fields near and in the planet itself. You might think of it like an electromagnet inducing an electrical current in a piece of copper, only, the copper in this case is the ground beneath your feet and the structures attached to its surface.

So, solar flares and CMEs cause magnetic disturbances which in turn create an electric disturbance in and around the Earth.  Great. The only question is: why does that affect things like power grids? After all, they are grounded for protection. Earth grounding means that your metal-encased washing machine is tied via your circuit breaker panel to a big conductive metal rod embedded in the ground. Any stray electrical currents due to malfunction will be safely conducted into the ground, and away from your hand. So what’s the deal here?

The problem is that during a geomagnetic storm, geomagnetically induced currents in the Earth itself sneak through the very grounding wires that are supposed to protect power grids, creating problems. Normally, GICs will mostly affect very long conductive wires or other metal structures like pipelines. It just so happens that in places like North America, there are very, very long power lines. There are many power plants, and there are lots of power transmission substations. The power plants generate electricity; the wires carry it all over the place, and the transmission substations act like traffic cops, deciding which set of power lines the electricity is to be directed to. In recent years, power deregulation has resulted in tons of switching, power sharing, and even the selling of electrical capacity from one region to another. If Region A doesn’t have enough juice, they just buy some from Region B. Region B taps away on their computer, et voila! Loads of electricity is routed through substations and over long, very-high-voltage wires to Region A. Cool, eh? Well, not really.

According to a paper entitled “Structural vulnerability of the North American power grid” published in February of 2004 in the journal Physical Review E, failures in only a small number of transmission substations could cause widespread blackouts in North America. The paper notes:

…[C]onnectivity loss is significantly higher, however, when targeting high degree or high load transmission hubs. The grid can withstand only a few failures of this nature before considerable parts of the network become disconnected leading to substantial connectivity loss at consumer levels.

For example, failure of only 4% of the nodes with high load may cause up to 60% loss of connectivity.1

In other words, if only a few percent of the key transmission substations that are heavily loaded were to fail, 60% of the continent could end up without power. Power usually isn’t generated in your local area anymore – it can be generated, sold, and shipped off to distant cities. The paper also notes that cascading power failures could be a rather large issue. If one substation fails, it will increase the load on other connected substations. The added load on the connected substations then causes those facilities to fail, and so on. In the case of a cascading failure, only 2% of the key substations would need to fail to cause a 60% blackout, and an 8% failure rate would result in a blackout of the entire continent!

Great – but what does that have to do with solar flares and GICs?

When you have very long transmission lines carrying power all over the place, you need to send that electricity at a very high voltage to minimize transmission losses. So, you stuff the electricity through a gizmo known as a transformer, which kicks up the voltage before you send it off. At the receiving end, there is another transformer which drops the voltage back down to something more manageable before it is then sent off to Mr. and Mrs. Johnson’s house.

Each of these transformers is grounded. You end up with something that looks like this:

Figure 3: Transformer affected by electrical current induced by a geomagnetic storm

The picture might be a bit clearer now. When GICs are created in the Earth, they can flow up the ground wire into a transformer (yup, that’s very backwards, and very bad). Transformers are very picky creatures, and they don’t like to become saturated – a technical way of saying “overworked”. GICs are more or less direct currents (DC), versus the alternating current (AC) of our power systems. Transformers REALLY don’t like DC.2 The end result of a geomagnetic storm created by a solar flare or CME is that the power lines themselves connected through their earth-grounded transformers act like a big loop antenna. Current flows up through the ground, into the transformer, and it starts to get overworked. It huffs and puffs and sometimes, it gets so hot that the insulation inside melts. At some point along the way, safety systems kick in and oops! Blackout.

Of course, there are other problems caused by GICs. High voltages can be created inside metal pipelines, leading to accelerated pipe corrosion and failure in older pipework. Railroad tracks are long metal rods, yes? How about those fiber optic cables that form the backbone of our communication networks? Well, short ones are okay because they aren’t conductive. But longer optical fiber lines have repeaters installed every so often. Repeaters are essentially optical amplifiers powered by electricity, which is – you guessed it – sent over wires embedded in the cabling containing the optical fiber!

The extent to which GICs can wreak havoc on a given electrical grid depends on many factors. Submarine optical fibers – even if they have electric repeaters – might not be affected as much since seawater is highly conductive and would act as a sort of shielding. One investigation showed that the shorelines of the United Kingdom were more highly susceptible to GICs due to their position on the seaside coupled with the particular geological makeup of the adjacent land.3 Supposedly Europe is much safer than North America due to its power grid structure, yet a cursory glance of certain geomagnetic event web sites indicates that plenty of problems have occurred in European countries in the past.4

And that brings us to the point: No one really knows for sure!

Space weather and its effects on the Earth and the technological systems of its inhabitants is a relatively young science. Even our understanding of the sun and solar flares is evolving as we learn more. Small storms have caused big problems in the past, and big storms have caused hardly any damage at all.

It is true that power companies could spend, say, $100 million dollars to install simple protection against GICs, but even that is not a guarantee. A strong enough solar-storm could theoretically have very serious effects even with the proper protective equipment.5 No one knows for sure – that’s the bottom line.

If you are interested in protecting yourself, I might recommend some sort of backup power generation system. A diesel generator might not be a bad idea, as long as you have enough fuel for it. During a widespread blackout, it might be difficult to produce, transport, or purchase fuel. Solar panels and wind power might come in handy. Problem is, all of these options are pretty expensive. And if it just so happens that other events intercede, such as the weakening of the Earth’s magnetic field (and magnetosphere), all bets are off .6

Then again, who knows… Maybe nothing will happen. There are so many factors that determine whether a given area will be affected by a given geomagnetic storm that it is very difficult to predict what will happen. Maybe we ought to just live through widespread blackouts lasting months or years, and then we’d break free of Big Oil and Big Electric and Big Brother, and come up with real solutions where everyone generates their own power safely and cheaply.

Or…

Maybe we would learn that we don’t really need our “digital lifestyle” as much as we think we do, and we’d rediscover the joy of simply living and laughing together.

Notes:

1 Albert R.,  Albert I., and Nakarado G. “Structural vulnerability of the North American power grid.” Physical Review E, Vol. 69, 2004.

2 Price, P. R. “Geomagnetically Induced Current Effects on Transformers.” IEEE  Power Engineering Review, Volume 22, Issue 6, 2002, p. 62.

3 www.geomag.bgs.ac.uk/documents/estec_gic_171201.pdf

4 www.solarstorms.org/SRefStorms.html

5 www.scribd.com/doc/33066153/geo-magnatically-induced-current [sic]

6 news.nationalgeographic.com/news/2008/06/080630-earth-core.html

Further Reading:

alienworlds.glam.ac.uk/sunStructure.html

aurora.fmi.fi/gic_service/english/about_ground_effects.html

www.opamp-electronics.com/tutorials/core_saturation_2_09_11.htm

Need help? Hire me!
Get Scottie Stuff!